Sony VPL-FX50 Manual De Instrucciones página 19

INPUT-A: Selects video signal input from the
INPUT A connector.
INPUT-B: Selects video signal input from the
INPUT B connector.
INPUT-C: Selects to display the Windows CE
window.
VIDEO: Selects video signal input from the
VIDEO (VIDEO IN) jack.
S-VIDEO: Selects video signal input from the S
VIDEO (VIDEO IN) jack.
4
Press the FOCUS key then the M or m key on the
Remote Commander to adjust the focus.
"LENS FOCUS" appears on the screen during
adjustment.
5
Press the ZOOM key then the M or m key on the
Remote Commander to adjust the picture size.
"LENS ZOOM" appears on the screen during
adjustment.
6
Press the FOCUS key and arrow keys on the
Remote Commander to adjust the focus again.
7
Press the SHIFT key then the M or m key on the
Remote Commander to adjust the vertical position
of the picture.
"LENS SHIFT" appears on the screen during
adjustment.
Note on focus and zoom adjustments
If the optional VPLL-ZM101, VPLL-ZM31 or VPLL-
FM21 lens is installed, perform the focus and zoom
adjustments manually.
To use the keys on the control panel for
focus, zoom and shift adjustments
Press the LENS CONTROL key repeatedly to display
the adjustment mode you want. Each press changes
the mode, "LENS FOCUS," "LENS ZOOM" and
"LENS SHIFT" in this order. Then press the arrow
keys to adjust.
Note
Looking into the lens when projecting may cause
injury to your eyes.
Cut off the picture
Press the PIC MUTING key on the Remote
Commander. To restore the picture, press the PIC
MUTING key again.
To get the clearest picture
You can get the suitable picture when a signal from
the computer is input. Press the APA key.
The picture is automatically adjusted to be projected
clearest.
Notes
• Adjust the signal when the still picture is displayed
on the screen.
• Press the APA key when the full image is displayed
on the screen. If there are black edges around the
image, the APA function will not function properly
and the image may extend beyond the screen.
• If you switch the input signal or re-connect a
computer, press the APA key again to get the
suitable picture.
• "ADJUSTING" appears on the screen. To restore the
original screen, press the APA key again during the
adjustment.
• "Complete!" appears on the screen when the picture
is adjusted properly. The picture may not be adjusted
properly depending on the kinds of input signals.
• Adjust the items in the INPUT SETTING menu
when you adjust the picture manually.
For details, see page 23 (GB).
To correct the trapezoid
When the projecting image is a trapezoid, perform the
shift adjustment with the SHIFT key.
If the image is still a trapezoid, correct it in DIGIT
KEYSTONE in the INSTALL SETTING menu.
When the base edge is longer than the upper
edge as shown in the figure below:
Set the value to negative.
When the upper edge is longer than the base
edge as shown in the figure below:
Set the value to positive.
For details on "DIGIT KEYSTONE," see page 27 (GB).
Projecting
19
(GB)