Connecting With A 15K Rgb/Component Equipment; Connecting To Lan - Sony VPL-FX50 Manual De Instrucciones

Connecting
Connecting with a 15k RGB/
Component Equipment
This section describes how to connect the projector
with a 15k RGB/component equipment.
Also refer to the instruction manuals of the equipment
to be connected.
Front of the projector
INPUT B
INPUT C
RGB (DVI)
ETHER
INPUT A
R/R-Y/P G/Y B/B-Y/P SYNC/HD VD
R B
MONITOR OUT
Monitor cable
(not supplied)
15k RGB/component equipment
Notes
• Set the aspect ratio using ASPECT in the INPUT
SETTING menu according to the input signal.
For details, see page 24 (GB).
• Select the input signal using INPUT-A in the SET
SETTING menu.
For details, see page 26 (GB).
• Use the composite sync signal when you input the
external sync signal from 15k RGB/component
equipment.
Connecting to a HDTV 1035/60i
Since the screen ratio of a high definition image is
16:9 and 576 lines are displayed in the vertical
direction, the image displayed is not a high-
definition image.
16
(GB)
PLUG IN POWER
TRIG
CONTROL S
VIDEO IN
RS-232C
S VIDEO VIDEO
VIDEO OUT
to RGB/component
output

Connecting to LAN

This projector is compatible with networking.
Installing a wireless LAN PC card or using the
ETHER connector enables you to connect the
projector to a wireless or wired LAN. You can also
install a PC memory card.
This section describes how to connect to LAN and
how to install a PC card.
Whenever you connect the projector to LAN, set
INPUT C FUNC. in the INSTALL SETTING menu
to ON.
For details, see page 27 (GB).
Installing a PC card
When you use a wireless LAN PC card or memory
card, insert the card into the INPUT C PC CARD
slot.
Open the lid of the slot, then insert the PC card
to the INPUT C PC CARD slot
Insert the card
with the arrow
mark facing
toward the slot.
PC card
The eject button pops out
when inserting.
To remove the PC card from the slot, press the eject
button.