Connector Panel - Sony VPL-FX50 Manual De Instrucciones

Location and Function of Controls

Connector panel

Front
2 3 4
INPUT B
INPUT C
RGB (DVI)
ETHER
INPUT A
R/R-Y/P G/Y B/B-Y/P SYNC/HD VD
R B
MONITOR OUT
1 0
1 INPUT A 5BNC connectors (R/R-Y/P
B-Y/P , SYNC/HD, VD connectors) (BNC type)
B
Connect to a high-resolution computer or VCR where
signals are transmitted long distances; for example,
when the projector is installed on the ceiling.
According to the connected equipment, computer,
component (R-Y/Y/B-Y), HDTV or DTV signal is
selected.
2 INPUT B RGB (DVI) connector
Connect to equipment equipped with the DVI output
(digital or analog RGB) using a commercially
available DVI cable.
3 INPUT C PC CARD slot (Type II)
A wireless LAN PC card or PC memory card can be
attached according to your requirement.
For details, see "Installing a PC card" on page 16 (GB).
4 INPUT C ETHER connector (10BASE-T)
Connect to a computer on the same LAN with the
LAN cable when you use the networking function of
this projector.
5 VIDEO IN connectors
Connect to external video equipment such as a VCR.
S VIDEO (mini DIN 4-pin): Connects to the S video
output (Y/C video output) on video equipment.
VIDEO (BNC type): Connects to the composite
video output.
12
(GB)
6 TRIG (trigger output) jack (monaural
minijack)
The signal is transmitted from this jack to the
connected equipment whether the projector is on or
off. (This is not a power source for external
equipment.) Approximately 12 V DC signal is output
when the projector power is on. The signal is 0 volt
level output when the projector power is off.
7 CONTROL S/PLUG IN POWER (DC 5V
5 6 7
output) jack (stereo minijack)
Connects to the control S out jacks of the Sony equipment.
Connects to the CONTROL S OUT jack on the supplied
Remote Commander when using it as a wired Remote
Commander. In this case, you do not need to install the
batteries in the Remote Commander, since the power is
PLUG IN POWER
TRIG
CONTROL S
supplied from this jack.
VIDEO IN
RS-232C
S VIDEO VIDEO
VIDEO OUT
8 RS-232C connector (D-sub 9-pin, female)
Connects to a computer to operate the projector from
9 8
the computer.
9 VIDEO OUT connectors
, G/Y, B/ S VIDEO (mini DIN 4-pin): Used as loop-through
R
VIDEO (BNC type): Used as loop-through output
q; MONITOR OUT connector (HD D-sub 15-pin,
female)
Connects to the monitor input connector on the
monitor. Outputs signals from the selected channel in
the INPUT A (5BNC) or INPUT B (DVI) connector.
This connector does not output any signals from the
DVI connector if the input signal is digital.
output via the S VIDEO IN connector.
via the VIDEO IN connector.