Sony VPL-FX50 Manual De Instrucciones página 20

Projecting
To turn off the power
1
Press the I / 1 key.
"Power OFF?" appears on the screen.
Note
The message will disappear if you press any key
except the I / 1 key, or if you do not press any
key for five seconds.
2
Press the I / 1 key again.
The ON/STANDBY indicator flashes in green and
the fan continues to run for about 120 seconds to
reduce the internal heat. Also, the ON/STANDBY
indicator flashes quickly for the first 40 seconds.
During this time, you will not be able to turn the
power back on with the I / 1 key.
3
Unplug the AC power cord from the wall outlet
after the fan stops running and the ON/STANDBY
indicator lights in red.
When you cannot confirm the on-screen
message
When you cannot confirm the on-screen message in a
certain condition, you can turn off the power by
holding the I / 1 key for about one second.
Note
Do not unplug the AC power cord while the
fan is still running; otherwise, the fan will
stop although the internal heat is still high,
leading to breakdown of the projector.
About the air filter cleaning
Clean the air filter every 300 hours to ensure
optimal performance.
To enlarge the image (Digital Zoom
function)
You can enlage the point on the image you select.
This function works only when a signal from a
computer (except for UXGA) is input.
1
Press the D ZOOM + key on the Remote
Commander.
20
(GB)
The Digital Zoom icon appears in the center of the
image.
2
Move the icon to the point on the image you want
to enlarge. Use the arrow keys (M/m/</,) to
move the icon.
3
Press the D ZOOM + key again.
The image where the icon is located is enlarged.
The enlargement ratio is displayed on the screen
for a few seconds.
By pressing the + key repeatedly, the image size
increases. (ratio of enlargement: max. 4 times)
Use the arrow keys (M/m/</,) to scroll the
enlarged image.
To return the image back to its original size
Press the D ZOOM – key. Just pressing the RESET
key returns the image back to its original size
immediately.
To freeze the image projected (Freeze
function)
Press the FREEZE key. "FREEZE" appears when the
key is pressed. This function works only when a
signal from a computer (except for UXGA) is input.
To restore the original screen, press the FREEZE key
again.
To use the Laser Pointer function
Press the LASER key on the Remote Commander.
The laser pointer appears. The pointer is helpful in
indicating a particular point on the screen.
Digital Zoom icon