Krups NOVO PLUS FNC1 Manual De Instrucciones página 20

Fill the water tank (1) (2) (3) and start the
•
appliance (5).
Move the steam nozzle to the exterior of the
•
appliance.
Turn the selector to the
•
Once the appliance reaches the correct
temperature, the orange temperature control
light will go out.
Immerse the steam nozzle in the container
•
holding the liquid to be heated.
• Then turn the selector to the
until the liquid is hot enough, then reset the
selector to the O setting and remove the
container.
For liquids other than water, turn the
•
selector to the setting
following cleaning operation in order to
prevent any blockage of the opening of the
steam nozzle :
place an empty container below the steam
•
nozzle.
select the setting again (20) to remove
•
the residue of the liquid.
turn the selector to the setting O.
•
Clean the steam nozzle with a damp cloth.
•
• For more thorough cleaning of the nozzle,
please refer to the paragraph on mainte-
nance.
Maintenance
- Never wash your espresso machine
accessories in the dishwasher.
After use, the water tank must be emptied.
. Drip plate
This must be emptied after using the
appliance after taking off the grid (22) (23). If
several espressos are being prepared one after
the other, the drip plate should be emptied
from time to time (about once every 7 - 8
espressos). The presence of water is normal
and does not signify a leak. If necessary, clean
the drip plate and its grid with water and a
little non-abrasive washing-up liquid, rinse
20
and dry. When reassembling the machine,
ensure that the plastic lining is in the right
place (24).
. The brewing head, the filter and the
filter holder
setting (19).
These must be cleaned after each use. All you
need to do is wipe a damp cloth over the
brewing head of your appliance and to wash
the other accessories in water and a little non-
abrasive washing-up liquid, rinse and dry.
If the brewing head is heavily clogged up,
unscrew the grid using a coin, clean it and
setting (20)
refit it, pressing down firmly (25).
When your espresso is not being used, do not
leave the filter holder on the appliance to
prevent wear on the gasket.
. The cup warming plate: remove this to
(19) for the
clean it with water and a little non-abrasive
washing-up liquid, rinse and dry (26).
. Steam nozzle: wipe with a damp cloth
after each use
. The cappuccino accessory
For more thorough cleaning the cappuccino
accessory can be dismantled.
•
•
•
•
•
However, we would advise you to use the
Krups descaling accessory, reference 054,
which is available from Krups after-sales ser-
vice centres. This accessory includes, apart
from two descaling doses, a testing strip for
Remove parts A and C from the metal tube
B (27).
Clean all three parts with hot water. If need
be, unclog the opening of part A using a
fine needle.
Be careful with the little plastic nozzle (part
A) when you replace the cappuccino accessory.
Descaling
Descaling of your espresso should be done
fairly frequently with citric or tartaric acid.
The guarantee does not include
espresso machines which do not
function, or do not function properly,
because descaling has not been carried
out.