Spring Preload With Air - Marzocchi TXC Manual Del Propietário

5.2.1 VA
This system allows adjustment of the spring pre-load and
the variation of air volume inside the fork leg.
• By turning the adjuster clockwise, you increase the
hydraulic damping during the compression phase.
• By turning the adjuster counter-clockwise, you reduce the
hydraulic damping during the compression phase.

5.2.2 Spring preload with air

Spring pre-load can be adjusted by varying the air pressure
inside the fork's leg.
By turning the adjuster clockwise, you increase the preload
value, by turning the adjuster counter-clockwise, you reduce
the preload value.
N
OTE
In some fork legs the air valve may not be in the central
position, in others however, it could be protected by a rubber
cap marked with «AIR».For infl ation, some systems require
the use of a specifi c adapter, which must be applied to the
pump. This adapter is supplied with the fork leg.
• Remove the protection cap.
• Tighten the pump adapter on the valve and infl ate till
reaching the pressure you wish.
• Refi t the protection cap.
Rider's kg 55-70
weight lbs 120-155 155-180 180-210 210-220+
Preload bar
air
psi
pressure
Table 9 - Preload pressures
AIR
70-80 80-95 95-110+
0 - 1.00
0 - 15
67