Descargar Imprimir esta página

Installation Instruction - bosal 010-228 Manual De Instrucciones

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
Packing list: 1 Cable set
1 Socket
1 Socket retaining plate
1.
Disconnect the earth lead from the battery.
2.
Uncover box along with cover in boot floor on the left side of the centre. Disassemble car jack. Disassemble left
loudspeaker cover and loudspeaker, if it is assembled.
3.
In order to connect electric bunch to connection socket disassemble grommet in vehicle. It is located on the back
wall, near jack holder.
Connect the cable set in the following way:
4.
a) Draw end of lead bunch with metal lead ends through the place referred to in point 3 from boot outside and
through a hole by connection socket handle,
b) Draw attached rubber socket retaining plate over the end of cable set (if necessary use anti-friction agent),
c) Disassemble the socket and connect cables according to the following assignment:
7 pin
Function
Indicator left
Fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Fog light
13 pin
Function
Indicator left
Trailer fog light
Rear fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
5.
Push the socket with rubber retaining plate and screw the socket tightly onto the retaining plate using the supplied
nuts and screws:
a) Pay special attention to the right position of rubber retaining plate,
b) Put the cable set gently to avoid any folds and to secure it from possible wiping.
Electrical Set for Trailer Connection
7-pin
13-pin
3 Screws M5X35
3 Nuts M5
3 Spring washer

Installation instruction

Contact description
Cable colour
1
(L)
black/white
2
(54-G)
3
(31)
brown
4
(R)
black/green
5
(58-R)
grey/red
6
(54)
black/red
7
(58-L)
grey/black
8
(58-b)
Contact description
Cable colour
1
black/white
2
2a
3
4
black/green
5
grey/red
6
black/red
7
grey/black
8
blue/red
9
red/blue 2,5mm
10
yellow 2,5mm
11
rown 2,5mm
12
13
white/brown 2,5mm
Part no. 010-228
Part no. 013-238
Honda CR-V Jeep manufactured 03.97-
2 Heat shrinkable tube
6 Cable ties
1 Sheet-metal screw
2
2
2
2
3 Quick connector (1x reserve)
1
2
6
7
3
5
4
8
Contact description in
7-pin socket
8
9
7
1
10
6
2
4
3
5
11
12
13
2a
Contact description in
13-pin socket

Publicidad

loading

Este manual también es adecuado para:

013-238