Installation Instruction - bosal 013-839 Manual Del Usuario

Mercedes m 04.98
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
23 11 13/ 05.13 / VA
Packing list: 1 14-conductor cable set
1 Socket
3 Screws M5X35
1.
Disconnect the earth lead from the battery.
2.
Remove rear part of roof upholstery lining, D pillar lining, loading edge casings and left lining of boot side
upholstery. Remove left rear lamp and draw cable set back to left rear lamp, behind left side boot lining.
3.
In order to draw cable set (connection to socket), remove passage casing from the vehicle side inside boot.
Connect cable set in the following way:
4.
a) Draw end of cable set with previously installed socket outside, through the passage referred to in item 3 inside
boot and then forwards, through the hole in socket-fixing handle.
13 pin
Contact description
Function
Indicator left
Trailer fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
5.
Connect
3-input casing to micro switch-key on the side of socket:
a) Assemble connection socket with packing washer using enclosed screws and nuts on socket holder,
b) Carefully fasten washer in the appropriate way,
c) Fasten electric bunch in such a way that there are no sharp bends and no wear.
Draw the remaining end of cable set with 16-input and 1-input plug connections to boot through the passage
6.
located in the vehicle.
a) Put the previously assembled rubber sleeve inside existing passage hole.
b connect 16-input plug connection of cable set to appropriate connection on vehicle side.
c) Partially remove insulation of cable set from vehicle side to rear parking lamp in an easily accessible place
before the sleeve running inside and cut the cable with fog lights function.
Cable colour, function, rear fog lights:
d) Insulate end of cable running to the rear fog lights (5 mm), clip the terminal and put it into 1-input housing.
Connect terminal housing with appropriate connection on the grey cable of cable set.
e) Wrap the remaining end of cable from vehicle side with insulating tape. This cable will not be used.
Electrical Set for Trailer Connection
13-pin
for Mercedes of M class (163 type) manufactured 04.98 -
Part no. 013-839
3 Spring washer
3 Nuts M5
1 Terminal

Installation instruction

Cable colour
1
black/white
2
grey /white
3
brown
4
black/green
5
grey/red
6
black/red
7
grey/black
8
blue/red
2
9
red/blue 2,5mm
2
10
yellow 2,5mm
11
white/brown 2,5mm
12
13
white/brown 2,5mm
vehicles produced by November 1999: light brown cable
vehicles produced from December 1999: blue cable.
1 Housing
3 Cable ties 100mm
4 Cable ties 300mm
10
11
2
Contact description in
2
1 Fuse 15A
8
7
9
1
6
2
4
3
5
12
13
13-pin socket

Publicidad

Tabla de contenido
loading

Tabla de contenido