Installation Instruction - bosal WYR410307R Instrucción De Montaje

Juego de conexión eléctrica de gancho de remolque para volvo country ab bj. 09.00. volvo s60 ab bj. 11.00. volvo s80 ab bj. 10.98. volvo v70 ab bj. 03.00.

Ocultar thumbs

página de 37

/ 37
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

4103 07R / 19.03.2019

1 7-conductor cable set

1 7-pin socket

Packing list:

1 Socket retaining plate

1 CL-01 relay

1. Disconnect the earth lead from the battery.

2. Exclusively for Volvo V70 and Country: remove the covers of the lateral boot lining and the covers of light holders.

Open the locker in the boot floor, remove its bottom part and the spare wheel.

Exclusively for Volvo S60/S80: remove the lateral cover of the boot and dismount the left lateral cover of the boot.

Open the right lateral cover of the boot and remove the locking system of rear seat back-rest. Dismount the cover of the

rear metal sheet piece.

3. In order to pass the cable bundle (the connection socket), drill a hole of diameter of approximately 6 mm in the boot

floor (on the right side near the battery ventilation system). Increase the drilled hole's diameter to approximately Ø 40

mm. Protect the drilled hole with an appropriate anticorrosive agent.

4. Connect cable set in the following way:

a) Pull outside terminal of 7-conductor cable set with metal cable tips from boot through the hole described in

clause 3, then pull through the hole in plug-in socket holder. Fasten attached grommet in the drilled hole.

b) There are two different washers under the socket. One is used by side entrance of leads, the other - in axis

entrance.

Side entrance: used in permanent assembly of tow hook with closed socket holder and detached tow hook

with folded socket holder. In such event, remove overpass in casing of connection socket.

Note !!! Use washer under socket assigned to side entrance for folded socket holder. Remove the other

washer assigned for axis entrance (it will not be used).

Axis entrance: used in permanent assembly of tow hook with opened socket holder and detached tow hook

without folded socket holder. Remove washer assigned for side entrance (it will not be used).

c) Socket is connected according to the following scheme:

Picture 1

Function

Indicator left

Trailer fog light

Earth

Indicator right

Tail light right

Stop light

Tail light left

5. Assemble connection socket with packing washer using enclosed screws and nuts on socket.

a) Carefully fasten washer in the appropriate way!

b) Fasten electric bunch in such a way that there are no sharp bends and no wear!

Electrical Set for Trailer Connection

7-pin Part no.

410307R

WYR

Volvo Country manufactured 09.00 – 08.04

Volvo S60 manufactured 11.00 – 08.04

Volvo S80 manufactured 10.98 – 08.04

Volvo V70 manufactured 03.00 – 08.04

1 Screws M5X10

3 Screws M5X35

4 Nuts M5

4 Spring washer