Publicidad
Idiomas disponibles
Idiomas disponibles
44 14 05 07/13 / 05.08 / VA
Packing list: 1 2-connection cable set
1 Cable set
1 Socket
1.
Disconnect the earth lead from the battery.
Remove screens near left standing lights in boot.
2.
In order to draw electric bunch to connection socket, remove grommet located on the left side of vehicle. Expand
3.
existing hole to 20 mm diameter. Secure the hole with anti-corrosion agent.
4.
Connect bunch to socket in the following way:
a) Draw end of cable bunch with metal cable ends through holes referred to in point 3 from boot outside and then
draw it through a hole near connection socket with 2-input bunch, install supplied grommet in drilled hole,
b) Put supplied rubber pad under socket on both bunch ends (if necessary, use lubricant),
c) Disassemble the socket and connect cables according to the following assignment:
7 pin
Function
Indicator left
Fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Fog light
13 pin
Function
Indicator left
Trailer fog light
Rear fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
5.
Push the socket with rubber retaining plate and screw the socket tightly onto the retaining plate using the supplied
nuts and screws:
a) Pay special attention to the right position of rubber retaining plate,
b) Put the cable set gently to avoid any folds and to secure it from possible wiping.
Electrical Set for Trailer Connection
7-pin
13-pin
1 Socket retaining plate
1 Rubber grommet
1 Screws M6
Installation instruction
Contact description
Cable colour
1
(L)
black/white
2
(54-G)
grey
3
(31)
brown
4
(R)
black/green
5
(58-R)
grey/red
6
(54)
black/red
7
(58-L)
grey/black
8
(58-b)
grey/white
Contact description
Cable colour
1
black/white
2
grey
2a
grey/white
3
brown
4
black/green
5
grey/red
6
black/red
7
grey/black
8
blue/red
9
red/blue 2,5mm
10
yellow 2,5mm
11
white/brown 2,5mm
12
13
white/brown 2,5mm
Part no. 004-978
Part no. 008-758
Honda Shuttle manufactured 95 -
3 Screws M5X35
3 Spring washer
3 Nuts M5
2
2
2
2
4 Cable ties 300mm
6 Cable ties 100mm
1 Sheet-metal screw
1
2
6
7
3
5
4
8
Contact description in
7-pin socket
8
9
7
1
10
6
4
2
3
5
11
12
13
2a
Contact description in
13-pin socket
Publicidad
