Cleaning And Care - Klarstein 10030845 Manual De Instrucciones

Battery Replacement
The fire is supplied with an IR multifunction remote. Before the remote will operate the plastic insulating sheet
needs to be removed.
1. Locate and remove the battery bracket.
2. The battery has two sides, one with a button feature, and the other is flat.
3. Insert the battery with the button side down into the battery bracket,
making sure the battery is firmly seated.
Important Hints on Use
• This product has one non-self-resetting overheat protection device. In the event that the heater stops wor-
king as a result of overheating take the following immediate steps: switch the electricity off at the socket and
remove the plug. Remove any objects that are covering the product.
• Do not touch the heater as it will be hot. Set the heater switches to OFF and leave the heater to cool down
fully. Once completely cool, reconnect the heater and switch it on.
• Do not open this product. There are no user-serviceable parts inside.
• Always disconnect the appliance from the mains supply outlet socket before undertaking any cleaning or
maintenance!
• For general cleaning use a soft clean duster - never use harsh abrasive or cleaners. The glass panels should
be cleaned carefully with a soft cloth.
• A correction pen has been included incase any part of the suite becomes damaged and requires a touch up
of paint. WARNING; For adult use/application only, do not allow children to use either of these pens. For
scratches, stroke in the direction of the scratch. For worn areas, stroke in the direction of the wood grain. Rub
any excess colorant promptly with a soft cloth. KEEP OUT OF REACH OF CHILDREN!
• When the battery becomes weak, the range of the remote control becomes shorter. Replace the battery
with a new CR2025 lithium battery. Note: Keep the lithium battery out of the reach of children.
•
Problem
Fire is not switching on.
Pebbles glow but flame
effect does not work.

Cleaning and Care

Troubleshooting
Possible Cause and Solution
Ensure mains switch is on.
Replace the fuse in the plug.
Check to see if the spinning motor is working. If not contact Focal Point Fires.
14