Coffee Brewing; Dispensing Hot Water - Saeco Sup 035DR Instrucciones De Uso

14
6

COFFEE BREWING

Note: Should the machine not brew coffee,
make sure that the water tank contains
water.
Before brewing coffee, check the messages
on the display. Check that the water tank and
coffee been hopper are full.
• (Fig.10 - Fig.11) - Place 1 or 2 cups beneath the
dispensing spout (4). You may adjust the height of
the dispensing spout to your cups.
• Check that the machine is ready. At this point a green
icon should be displayed.
• (Fig.12) - To brew coffee:
- If desired, press and release the aroma button (18)
to select the desired aroma.
- Press and release small coffee button (14) for an
espresso coffee, or long coffee button (15) for a long
coffee.
• The brewing cycle is started:
- To dispense 1 cup of coffee, press the button once.
A green icon appears on the display:
or
- To dispense 2 cups of coffee, press the button twice.
A green icon appears on the display:
or
In this mode of operation, the machine
automatically grinds and doses the correct
amount of coffee. Brewing two coffees requires two
grinding cycles and two brewing cycles, which the
machine carries out automatically.
• After the prebrewing cycle, coffee begins to dispense
out of the dispensing spout (4).
• Coffee brewing stops automatically when the pre-
programmed level is reached; however, it is possible
to interrupt coffee brewing by pressing the button
initially pressed.
DISPENSING HOT WATER - PREPARING A CAPPUCCINO
The machine is adjusted to brew a real Italian
espresso. This feature may slightly lengthen
the brewing time, allowing the intense fl avor of the
coffee to develop fully.
7

DISPENSING HOT WATER

Warning: At the beginning, short spurts of hot
water may come out: Danger of scalding. The
hot water/steam wand may reach high temperatures:
Never touch it with bare hands.
• Before dispensing hot water, check that the machine
is ready. At this point a green icon should be dis-
played:
When the machine is ready to brew coffee, proceed as
follows:
• (Fig.7) - Place a cup or a container beneath the hot
water/steam wand (7).
• (Fig.8) - Turn the hot water/steam knob (10) clockwise
to open it. A green icon will be displayed:
• When the desired quantity of hot water has been
dispensed, turn the hot water/steam knob (10) coun-
ter-clockwise to stop it. The machine returns to the
normal operating mode.
Occasionally, no hot water is dispensed when
the hot water/steam knob (10) is turned and
an orange icon will appear on the display:
Should this happen, simply wait until the end of the
pre-heating phase, at which point hot water will be
dispensed from the Pannarello.