Assembly And Adjustments - DeWalt DW849 Traducido De Las Instrucciones Originales

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Mounting the Side Handle (fi g. 2)
Screw the side handle (e) tightly into one of the holes
on either side of the tool.
Fitting and Removing the Backing
Pad (fi g. 3)
1. Place the tool on a table, spindle up.
2. Press the spindle lock (d) and turn the spindle
until the lock engages.
3. Place the backing pad (f) onto the spindle.
4. Screw the threaded flange (g) onto the spindle.
5. Tighten the threaded flange.
6. Release the spindle lock.
7. To remove the backing pad, loosen the
threaded flange while the spindle lock is
engaged.
Fitting the Polishing Bonnet (fi g. 4)
1. Place the tool on a table, spindle up.
2. Pull the polishing bonnet (h) over the backing
pad (f).
Prior to Operation
1. Be sure the threaded flange is mounted
correctly.
2. Make sure the pad rotates in the direction of the
arrows on the accessory and the tool.
3. Make sure any dirt is washed off the workpiece
surface.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING:
• Apply only a gentle pressure to the
tool. Do not exert side pressure on the
backing pad.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Polishing (fi g. 1)
1. Always use clean polishing bonnets.
2. Evenly apply a required amount of polishing
paste over the polishing bonnet.
3. Hold the polishing bonnet to the surface to be
polished and switch on the tool.
4. Move the tool evenly over the surface, without
applying pressure.
5. Switch off the machine before taking the tool
from the surface.
6. Check your work at short intervals.
WARNING: High-speed rubbing
action of the polishing bonnet upon the
workpiece surface can build a static
charge on the metal portions of this
tool resulting in a static shock when
touched.
Proper Hand Position (fi g. 7)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the side
handle (e), with the other hand on the main
handle (i).
Switching On and Off (fi g. 5)
1. To run the tool, press the variable speed switch
(a). The pressure exerted on the variable speed
switch determines the tool speed.
2. For continuous operation, also press the lock-
on button (b). The lock-on button works only in
full speed.
3. Switching off: press the on/off switch again.
WARNING: Do not switch the tool on
or off when under load.
Speed Control (fi g. 6)
The speed control dial (c) can be used for advance
setting of the required maximum tool speed.
1. Turn the speed control dial (c) to the desired
position. The higher the number, the higher the
maximum tool speed.
EN G LI SH
27