Sauder 420406 Instrucciones De Montaje página 6

Step 2
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (1) to the EXTENSION BLOCKS on each END (A and B) as shown. Use four
å
BLACK 1/2" FLAT HEAD SCREWS (24).
NOTE: For each EXTENSION RAIL, turn a SCREW into the holes shown in the upper diagram below.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Fasten the RIGHT CABINET RAIL (3) to the EXTENSION BLOCK on the RIGHT END (A) and the LEFT
å
CABINET RAIL (4) to the EXTENSION BLOCK on the LEFT END (B). Use four BLACK 1/2" FLAT HEAD
SCREWS (24) through the 1st and 9th holes in the RAIL.
Fasten six METAL BRACKETS (15) to the edges of the ENDS (A and B) as shown. Use six BLACK 1/2" PAN
å
HEAD SCREWS (25).
NOTE: Be sure the BRACKETS are even with the edges of the ENDS.
å
Push down on the release lever and
pull the SLIDE (2) from the RAIL (1).
1
BLACK 1/2" FLAT HEAD SCREW
(8 used for the RAILS)
B
Page 6
2
24
1
4
24
Roller end
Use these holes.
25
15
Open end
A
25
15
www.sauder.com
2
Extension Rail and
Slide separated
1
24
3
1
BLACK 1/2" PAN HEAD SCREW
(6 used for the METAL BRACKETS)
Roller end
Open end
25
420406