Battery Pack; Storage Recommendations; Package Contents - DeWalt DCN690 Traducido De Las Instrucciones Originales

make sure that the battery terminals are protected
and well insulated from materials that could contact
them and cause a short circuit.
The information provided in this section of the
manual is provided in good faith and believed to be
accurate at the time the document was created.
However, no warranty, expressed or implied, is
given. It is the buyer's responsibility to ensure that its
activities comply with the applicable regulations.

Battery Pack

BATTERY TYPE
The DCN690, DCN691 and DCN692 operate on an
18 volt battery pack.
The DCB180, DCB181, DCB182, DCB183,
DCB184 or DCB185 battery packs may be used.
Refer to Technical Data for more information.

Storage Recommendations

1. The best storage place is one that is cool and
dry away from direct sunlight and excess heat
or cold. For optimum battery performance and
life, store battery packs at room temperature
when not in use.
2. For long storage, it is recommended to store a
fully charged battery pack in a cool, dry place
out of the charger for optimal results.
NOTE: Battery packs should not be stored
completely depleted of charge. The battery pack will
need to be recharged before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
Read instruction manual before use.
Charging.
Fully charged.
Hot/cold pack delay.
x
Problem pack or charger.
Problem powerline.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Charge D WALT battery packs only with
E
designated D WALT chargers. Charging
E
battery packs other than the designated
D WALT batteries with a D
E
may make them burst or lead to other
dangerous situations.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 °C and 40 °C.
Discard the battery pack with due care for
the environment.
Do not incinerate the battery pack.
Charges Li-Ion battery packs.
See Technical data for charging time.

Package Contents

The package contains:
1 Nailer
1 Charger (M2 or P2 models only)
2 Battery packs (M2 or P2 models only)
1 Non-mar tip
1 Kitbox (M2 or P2 models only)
1 Instruction manual
NOTE: Battery packs, chargers, and kit boxes are
not included with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Trigger
b. Trigger safety lock-off
EN GL IS H
WALT charger
E
53