Pushing/Towing The Machine; Machine Storage; Maintenance; Scheduled Maintenance Table - Nilfisk Advanced Terra 4300B Instrucciones De Uso

Ocultar thumbs Ver también para Advanced Terra 4300B:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH

PUSHING/TOWING THE MACHINE

To push/tow the machine when it is turned off, no special prearrangement is necessary.

MACHINE STORAGE

If the machine is not going to be used for more than 30 days, proceed as follows:
Perform the procedures shown in After Machine Use paragraph.
Check that the machine storage area is dry and clean.
Disconnect the battery connector (46).

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
WARNING!
To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, the
batteries must be disconnected.
Moreover, carefully read the instructions in Safety paragraph.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorized Service
Center.
The Instructions for Use Manual contains the Scheduled Maintenance Table and describes only the easiest and most common
maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery charging
WET battery fluid level check
Main broom cleaning
Side and main broom height check and adjustment
Dust filter cleaning and integrity check
Skirt height and operation check
Filter shaker operation check
Main broom driving belt visual inspection
Service and parking brake check and adjustment
Steering chain check and cleaning
Main broom driving belt replacement
Main motor and drive system motor carbon brush check or
replacement
(*)
For the relevant procedure, see the Service Manual.
(1) Daily or after using the machine.
(2) Or before start-up.
(3) Or more often in dusty areas.
(4) Or more frequently if the machine is used on slopes.
16
INSTRUCTIONS FOR USE
Terra™ 4300B - 1464035000
Every 10
Upon delivery
hours
(1)
(2)
(3)
revised 03/2018
Every
Every
Every 50
100
200
hours
hours
hours
(*)
(*)
(*) (4)
(*)
(*)
Every
400
hours
(*)
06/2009

Publicidad

Tabla de contenido
loading

Tabla de contenido