Descargar Imprimir esta página

Installation Instructions - Valley 30524 Instrucciones De Instalación

Publicidad

Brake Control Wiring Harness

INSTALLATION INSTRUCTIONS

Note: This harness has been designed for use with
Valley™ brake controls containing
a pre-wired harness conector
(Fig. 1). For all other brake
controls, use Valley harness part
number 30420.
1. Read instructions thoroughly before beginning.
2. Locate the vehicle's OEM
brake control connector under
the dash (Fig. 2). The connector
will be similar to that found on
the Brake Control Wiring Harness
and designed to mate with it. The
mating plug will be taped to an
existing harness under the dash,
near the emergency brake pedal
(Fig. 3). If the vehicle is equipped
with a factory brake controller,
locate the plug that matches
the housing on the harness. It
will be located under the dash,
near the emergency brake
pedal. Refer to the vehicles
owners manual for additional
information in locating this
connector.
Fig. 1
Fig. 2
Fig. 3

Publicidad

loading