Error Messages; Instructions For Use - Varian Turbo-V 1800 Manual De Instrucciones

INSTALLATION
The Turbo-V controller is equipped with a 3-wire
power cord and plug (internationally approved) f ? r
user safety. Use this power cord and plug m
conjunction with a properly grounded power socket
to avoid electrical shock.
High voltage developed in the controller can cause
severe injury or death. Before servicing the unit,
disconnect the input power cable.
The Turbo- V controller can be used as a bench unit
or a rack module, but it must be positioned so that
free air can flow through the holes.
Do not install or use the controller in an environment
exposed to atmospheric agents (rain, snow, ice),
dust, aggressive gases, or in explosive environments
or those with a high fire risk.
During operation, the
conditions must be respected:
•
temperature: from O °C to +40 °C;
•
relative humidity:
condensation).
To connect the controller to the pump use the
specific cable supplied with the controller.
The controllers model 969-9461 and 969-9561 are
supplied with the pump cable fixed to the controller
rear panel.
See the appendix "Technical
detailed Information about the above mentioned and
the other connections,
installation.
USE
This paragraph describes the fundamental operating
procedures. Detailed
procedures that envolve
option are supplied in the paragraph UUSE" of the
appendix "Technical Information".
Make all vacuum manifold and electrical connections
and refer to Turbo-V pump instruction manual before
operating the Turbo-V controller.
To avoid injury to personnel and damage to the
equipment, if the pump is laying on a table make
sure it is steady .
Never operate the Turbo-V pump if the pump inlet is
not connected to the system or blanked off.
WARNING!
NOTE
following environmental
0 95% (without
NOTE
Information"
and about the options
information and operating
optional connection
WARNING!
The forepump and Turbo-V pump can be switched
on at the same time.
Controller controls, indicators and connectors
The figures in the following page illustrates the
Controller control panel and interconnection panel.
More details
"Technical Information".
USE PROCEDURE
Controller Startup
To startup the controller plug the power cable into a
suitable power source. Switch the main circuit
breaker on the rear panel to ON.
Starting the pump
To start the pump press the START push-button on
the controller front panel.
Pump Shutdown
To shutdown the pump press the STOP push-button
on the controller front panel.
MAINTENANCE
The Turbo-V 1800 series controller does not require
any maintenance.
controller must
personnel.
for
When a fault has occurred it is possible to use the
Varian repair service. Replacement controllers are
available on an advance exchange basis through
Varian.
or
Before carrying out any work on the controller,
disconnect it from the supply.
If a pump is to be scrapped, it must be disposed off
in accordance with the specific national standards.

ERROR MESSAGES

For a certain type of failure, the controller will self­
diagnose the error returning codes from O to 6 in a
singre digit error code on the fault display. Error
codes are described in the table at the end of the
chapter.
INSTRUCTIONS
NOTE
are contained in the
Any work performed on
be carried out by
WARNING!
FOR
USE
appendix
the
authorized