Epson IR-320 Manual Del Usuario página 17

Do not use the unit in locations subject to high humidity or dust levels.
Excessive humidity and dust may cause equipment damage, fire, or shock.
Do not use the product where inflammable fumes of gasoline, benzine,
thinner or other inflammable liquids may be in the air. Doing so may cause
an explosion or fire.
Do not place heavy objects on top of this product. Equipment may fall or
collapse, causing breakage and possible injury.
To ensure safety, unplug this product before leaving it unused for an
extended period.
Do not drop, bump, or otherwise subject this product to strong vibration
or impact.
Do not block the openings on this product. They are provided for the
ventilation necessary to ensure reliable operation and protection from
overheating.
Be sure to attach all covers after setup. If they are not attached, foreign
matter may enter this product and it may not operate correctly.
Never clean the product with thinner, benzene, alcohol, or other such
solvent.
Do not use this product with any voltage other than the specified one.
Doing so may lead to fire.
When a power cable for the TM printer is connected, do not short-circuit
its connector pins.
Do not insert fingers or foreign matter into the CD-ROM disk tray or
openings. Doing so may lead to fire, shock, or injury.
Do not insert fingers or foreign matter into the Front CompactFlash
Adapter opening. Doing so may cause equipment damage.
Never hold this product by the rear cover, the front panel, or the
CD-ROM disk tray. They cannot support the weight of the product, so it
may fall onto the floor.
Make sure that the total power requirements of all devices receiving
power from this product do not exceed the power limitation. See the
specifications for more detailed information.
Be sure to use this product with all covers attached.
Be careful not to cut your finger on any edge of the unit.
Be sure to use EPSON supplied DIMMs, HDDs, CPUs, and KBs.
To get the latest information about which CompactFlash Memory Card
or Adapter or PCI board can be used with this product, contact your
EPSON dealer.
If you turn off the unit, wait longer than 10 seconds before you turn it on
again.
Be sure to attach the HDD cover when you use this product. If the cover
is not attached, the product may not operate correctly.
English
IR-320 User's Manual 5
TM