Operation Procedure - Epson IR-320 Manual Del Usuario

Inserting a CompactFlash Card
Insert the CompactFlash card face up firmly into the slot to set it in
place, as shown in illustration M.
Removing a CompactFlash Card
Press the eject button firmly. The CompactFlash card is ejected slightly
from the slot so you can remove it, as shown in illustration N.
Using BaySwap
If you are running Windows NT with the BaySwap program installed,
read these instructions.
The BaySwap icon resides in the task bar, as shown in illustration O,
when Windows NT is booted.

Operation Procedure

Make sure that reading or writing is not being performed on the
CompactFlash card before removing it.
1. Click the icon in the task bar, and then click [Change device in
Swappable Bay]. (See illustration P.)
2. The dialog box shown in illustration Q is displayed. Insert or
remove the card at this point.
3. Click OK once the card has been inserted or removed.
Reset
Reset restarts the computer while the power is on. Reset is necessary
only when software has entered an endless loop.
CAUTION:
Do not press the reset switch unless the system fails to respond.
When the system is reset, all data in memory is lost.
Perform a reset by following the procedure below.
1. Open the front panel. If the front panel is locked, unlock it using
the front key.
2. Push the reset switch with a pointed object such as a pen, as
shown in illustration R.
IR-320 User's Manual 13
English