Epson IR-320 Manual Del Usuario página 24

English
CD-ROM/R/RW Emergency Ejection
When the CD-ROM, CD-R/RW drive does not function properly, you
can remove the CD-ROM/R/RW by following the steps below:
1. Turn off the IR-320.
2. Insert a small thin object, such as an extended paper clip, in the
CD-ROM eject hole. (Shown in illustration L, with the CD-ROM drive
shown on the left and the CD-R/RW drive shown on the right.)
3. The disk tray pops out slightly; then pull it out gently.
CompactFlash Cards
Handling CompactFlash Cards
CompactFlash cards are composed of precision electronic components.
Follow the cautions below to prevent incorrect operation or failure of
the cards.
CAUTION:
Do not touch the terminals of a CompactFlash card with your fingers or
any metal object because electrostatic discharge may damage internal
components. Before touching a card, discharge your electrostatic charge
by touching a metal fixture. Failure to do so may damage the system.
Unless you are using BaySwap
CompactFlash card while the system is on. If you have installed BaySwap,
refer to the BaySwap operation procedure below. Failure to observe these
precautions may result in system damage.
Do not bend or drop the card, and protect it from impact.
Protect the card from excessive heat, moisture, and direct sunlight
during use and storage.
Inserting and Removing CompactFlash Cards
Observe the following requirements when inserting and removing
CompactFlash cards.
When the power is on
When the power is off
See "Using BaySwap" for details on the procedure for inserting and
removing CompactFlash cards when BaySwap is in use.
BaySwap can be used only with Windows NT.
12 IR-320 User's Manual
®
under Windows NT, never remove the
BaySwap not in use:
BaySwap in use:
Inserting and removing not possible.
Inserting and removing possible.
Inserting and removing possible.