Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 93
8. Select "Save & Exit Setup" with the cursor key; then press the
Enter key.
9. When "Save to CMOS and Exit (Y/N)?" is displayed, press the Y
key; then the Enter key. The utility setup is finished.
Power
When you use this product for the first time, turn on the main power
switch. The "O" mark indicates off, and the "|" mark indicates on, as
shown in illustration A.
The main power switch should usually be kept on. Turn off the unit's
main power switch only when attaching peripherals, before
transporting it, when it will not be used for an extended period of time,
or in the unlikely event that the unit produces strange noises or smoke.
With the main power switch on, you can press the soft power switch
on the front of the unit to turn the unit on and off, as shown in
illustration B. The soft power switch uses software to turn your system
on and off, but even when the unit is turned off with this switch, a
small amount of current is flowing.
When a problem in the unit causes the protection circuit to be used, the
soft switch does not work. If this happens, turn off the main power
switch, remove the cause of the problem and wait for about 10 minutes.
Then turn on the main power switch and then the soft switch.

Power Off

You usually turn off power through your software. The power off
procedure varies depending on the operating system and BIOS used.
Power Switch Covers
This product includes 2 switch covers that prevent the unit from being
turned on or off accidentally. To install a switch cover, place the switch
cover over the switch, and press it into place, as shown in illustration C.
When you have installed a switch cover, operate the switch by
pushing a thin object, such as a pencil, through the holes in the switch
cover, as shown in illustration D.
English
IR-320 User's Manual 9

Publicidad

Tabla de contenido
loading

Tabla de contenido