Cleaning The Ring Insert; Help With Problems; Disposal - NUK Thermo Light+ Manual Del Usuario

7.2 Cleaning the ring insert

Clean ring insert 2 by hand in the sink.
Faults can occur in any electrical appliance. This does not necessarily mean that the appliance is
defective, so please check the list to see whether the fault can be eliminated.
Problem
Appliance not working. There is no power supply.
Appliance is damaged
(e.g. cracks, glass or
power cord defective).
Dial will not move.
Infrared lamp defective Broken filament
The symbol with the crossed-out
rubbish bin on wheels means that
within the European Union, the
product must be disposed of to a
sorted rubbish
applies to the product and all
accessories which are marked with
this symbol. Marked products must not be
disposed of via the regular domestic waste but

8. Help with problems

Reason
Temperature sensor has tripped.
Electromagnetic fault from the
mains supply has set the
appliance to its "safe state".
Overheating cutout has tripped.
Mechanical action
Mechanical fault

9. Disposal

collection. This
Check whether the plug is in a socket.
Check the fuses at the fuse box in your
home.
Wait 10 minutes until the appliance has
cooled down and then try again.
Take the plug out of the socket. Put the
plug back in the socket and switch
appliance back on.
Take the plug out of the socket. Contact
the service address (see "Contact
addresses" on page 99).
must be handed in to a recycling centre for
electrical or electronic devices. Recycling helps
to reduce the use of raw materials and to relieve
the environment. It is therefore imperative that
you follow the disposal regulations applicable in
your country.
23
Remedy
G
B