Normal calibrate
After enter cal mode, the display will show UnLoAd. Remove all weight from the pan and wait for
stable.
After stable, balance will show LoAd, put calibrate weight on the pan, here is the useable weight list.
300g:
30/40/50/60/70/80/90/100/110/120/130/140/150/160/170/180/190/200/210/220/230/240/250/
260/270/280/290/300
600g:
60/80/100/120/140/160/180/200/220/240/260/280/300/320/340/360/380/400/420/440/460/480
P2 CAL
/500/520/540/560/580/600
1500g:
150/200/250/300/350/400/450/500/550/600/650//700/750/800/850/900/950/1000/1050/1100/1 150/12
00/1250/1300/1350/1400/1450/1500
3000g:
300/400/500/600/700/800/900/1000/1100/1200/1300/1400/1500/1600/1700/1800/1900/2000/21 00/22
00/2300/2400/2500/2600/2700/2800/2900/3000
after stable, dosplay will show pass, calbrate complete.
No need press any jey during calibrate.
P3 Cnt
This display will show xxxxxx for indicating the internal counts, you can press
This option is used to select the auto zero maintain
P4 A2n
Options: OFF, 0.5d, 1d, 2d, 4d, Use
This is used to adjust gravity, when move to another place with big latitude change, you can use this
function to adjust.
After press
key to enter this function, you can use
(Use
and
P5 GrA
Latitude rate= local latitude/the latitude of the calibrate place.
For example, local latitude is 9.85, the latitude of the calibrate place is 9.75, by this way, the read-ing
data will be bigger than standard, you need input 1.01025, then reading will be correct. Note: after you
do calibrate, this rate will reset to 1.00000.
Set capacity, press
P6 CAP
can select 150g/200g/1500g/2000g, after you select, press
P7 SPD
Converter speed L / m / H (low / medium / high)
P8 S-t
Multi-tare ON / OFF
P9 ret
Ok
key to shift, press
key move active digits, use
key to select: 300g/600g/1500g/3000g/6000g, for high resolution model, you
USER MANUAL BAR
key to sure, press
,
,
key to key in the latitude rate
key incease value), after input, press
to confirm.
EN
EN
key to escape.
key to scape.
key to sure.
37