Output; Parameters - Baxtran BAR Manual De Instrucciones

7. OUTPUT

The BAR series scales can be ordered with an optional RS232 output.
Specifications:
• RS232 output of weighing data
• ASCII code
• 9600 Baud
• 8 data bits
• No parity
Connector: 9 pin d-subminiature socket
• Pin 2: Rx
• Pin 3: Tx
• Pin 5: GND
Continuous output protocol.
,
-HEADER 1- -HEADER 2-
HEADER1: ST= STABLE, US= UNSTABLE
HEADER2: NT= NET, GS = GROSS
NOTE: For the proper functioning of the equipment, use only 3-wire RS232 cables.

8. PARAMETERS

The scale has 9 parameters that can be set by the user plus a method of entering the calibration section.
To set parameters press the
The display will show the first function, "F1 UNIT" .
Pressing the key will cycle through the other functions.
Pressing key will allow you to set the function. Use the
NOTE: When the display shows "TECH" in the verified equipment, press the "CAL SWITCH" then press the key.
enter, display shows "PIN" , press
PARAMETERS TABLE
FUNCTION
Sets the which units want to use: g / ct / lb / oz / d / gn / ozt / dwt / mm / tl.T / tl.c / tl.t / t use
F1 Unt
switch, use
Set the backlight to be on, automatic or off.
EL on: Backlight always on
EL Au: Backlight automatically turn on
F2 bL
EL off: Backlight allways off
Use
Set RS232
At first, select you will use RS232 or USB..
S 232: use RS232 interface
S USB: use USB interface. (not available)
Then will select interface work mode.
P Prt connect with mini printer.
P Cont connect with remote display or PC
P Auto connect with mini printer, auto printer, auto print (auto accumulation)
F3 Con
wirELE: wireles.
After you select communication mode, display will show b xxx, this is baud rate, you can select from
600, 1200, 2400, 4800 or 9600 bps.
If you select P Prt o P Auto (work with printer), after set baud rate, display will show tP or LP-50, this is
printer mode, you can select normal mini printer (tP) or label printer (LP-50).
If you select LP-50, display will show EnG o CH, this is print out language, you can select Chinese (CH) or
English (EnG). Use
SALE M N/Y Sales mode
-/
-WEIGHT DATA-
key during self checking.
, , key, and press
key to sure.
to switch, use key to sure.
to switch, use
key to leave a parameter unchanged.
key to enter technical parameters setting mode.
DESCRIPTION
key to sure.
USER MANUAL BAR EN EN
k g CR LF
-WEIGHT UNIT-
TERMIANTOR
key to
to
35