Stanley FATMAX SFMCE530 Traducido De Las Instrucciones Originales página 10

ENGLISH
Charge only at ambient temperatures
u
between 10 °C and 40 °C.
Charge only using the charger
u
provided with the tool.
When disposing of batteries, follow the
u
instructions given in the section
p "Protecting the environment".
Do not attempt to charge
damaged batteries.
Chargers (Not Supplied)
Use your STANLEY FATMAX charger
u
only to charge the battery in the tool
with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
Have defective cords replaced
u
immediately.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
$
u
The charger is intended for
indoor use only.
+
Read the instruction manual
before use.
Electrical safety
#
Your charger is double insulated;
therefore no earth wire is
required. Always check that the
mains voltage corresponds to
the voltage on the rating plate.
Never attempt to replace the
charger unit with a regular mains
plug.
10
(Original instructions)
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised STANLEY FATMAX Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/off trigger switch
2. Air vents
3. Nozzle
4. Heat barrel cover
5. Lock off
Use
Warning! Let the tool work at its own pace. Do not overload.
Charging the battery (Not Supplied) (Fig. A)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before.
The battery may become warm while charging; this is normal
and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger will
begin to charge automatically when the cell temperature
warms up or cools down.
Note: To ensure maximum performance and life of lithium-ion
battery packs, charge the battery pack fully before first use.
Plug the charger (7) into an appropriate outlet before
u
inserting battery pack (6).
The green charging light (7a) will blink continuously
u
indicating that the charging process has started.
The completion of charge will be indicated by the green
u
charging light (7a) remaining ON continuously.
The battery pack (6) is fully charged and may be removed
and used at this time or left in the charger (7).
Charge discharged batteries within 1 week. Battery life will
u
be greatly diminished if stored in a discharged state.
Charger LED Modes
Charging:
Green LED Intermittent