GB
PRODUCT SPECIFICATION
The cotton candy machine is used to prepare cotton candy. The product is designed for use with granulated sugar only. The pro-
duct is designed for domestic use only and may not be used in commercial applications. The correct, reliable, and safe operation
of the device depends on its proper use, which entails:
Reading and keeping the entire manual before the fi rst use of the device.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
specifi ed in this manual.
ACCESSORIES
The product is delivered complete, but requires carrying out a number of preliminary actions described in further sections of the
manual. Sticks for winding cotton candy and a sugar measuring spoon are supplied with the product.
SAFETY INSTRUCTIONS
CAUTION! Read all of the following instructions. Failure to do so may result in electric shock,
fi re, or injury.
FOLLOW THE INSTRUCTIONS BELOW
Do not use the product in an explosive environment containing fl ammable liquids, gases, or
vapours.
Set the device on fl at, even, and hard surfaces. If the device is equipped with rubber feet or
suction cups, select a surface type such that the feet or pads prevent the device from moving
during use.
Do not place the device near any heat or fi re sources.
Connect the device only to the power network with the voltage and frequency indicated on
the nameplate of the device.
The plug of the power cord must match the power socket. Do not modify the plug. Do not use
any power adapters to adapt the plug to the socket. An unmodifi ed plug, which matches the
socket, reduces the risk of an electric shock.
After each application, unplug the power cord from the power socket. Do not disconnect the
plug by pulling on the cable. Pull the plug out of the socket, always grasping it by its housing.
Avoid direct contact with grounded surfaces such as piping, radiators and refrigerators.
Grounding of the body increases the risk of an electric shock.
The device is intended for indoor use only. Do not expose the device to any precipitation or
moisture. If water and moisture enters the device, the risk of an electric shock is signifi cantly
increased. Do not immerse the product in water or any other liquid. Do not pour water into
the product bowl during operation.
Do not overload the power cord. Do not use the power cord to carry, connect, or discon-
nect the plug from the power socket. Avoid any contact between the power cord and heat
sources, oil, sharp edges, and moving parts. Damage to the power cord increases the risk
of an electric shock. If the power cord is damaged (e.g. it is cut, its insulation is melted), im-
mediately unplug it from the wall socket, and return it to an authorised service facility. It is not
O R I G I N A L
I N S T R U C T I O N S
10