Maintenance And Storage; Technical Parameters - LUND 68250 Manual De Instrucciones

Use wooden or paper sticks to wind the cotton candy. The stick should have a rough surface, which will make it easier for the
cotton candy to adhere to it.
Pour one measure of sugar carefully into the heated head. Do not pour sugar into other parts of the product.
Start the product with the switch. Observe the product, after approx. 1 - 2 minutes the threads of cotton candy will start to form.
Insert the winding stick vertically into the bowl and, without touching the head, guide it around the circumference of the bowl while
rotating it around the axis (V).
The cotton candy will start wrapping around the stick. Then carefully pull the cotton candy stick out of the bowl, rotate it horizontally
in relation to the bowl and continue winding the cotton candy while continuing to guide the stick around the circumference of the
bowl while rotating it around the axis (VI). The cotton candy is ready when its amount that is wound on a stick ceases to increase.
CAUTION! The slower the rotation of the stick with cotton candy, both around the bowl and around the axis, the fl uffi er the cotton
candy will be.
CAUTION! Avoid touching the rotating head with the cotton candy on the stick. Cotton candy can be caught by the head.
When you have fi nished winding the cotton candy, turn off the device using the switch and wait for the head to stop. Then wait
about one minute for the head to partially cool down.
Pour another portion of sugar into the head and start winding the cotton candy again or unplug the power cord from the socket,
wait for the product to cool down on its own and proceed with maintenance.
WARNING! The head heats up to a high temperature. Be careful to avoid burns. Do not touch the head during or immediately
after operation.
CAUTION! Never pour sugar into the rotating head. Always wait for it to stop.
CAUTION! Do not use plastic sticks for winding, they may melt or deform under high temperature.

MAINTENANCE AND STORAGE

Caution! As the product is used for food preparation, maintenance must be carried out as soon as work is completed. Only proper
maintenance will ensure the right level of hygiene.
When you have fi nished, turn off the product, wait for rotation to stop completely, unplug the power cord from the wall socket and
leave the product to cool down on its own. Do not accelerate the cooling of the head, for example by immersing it in water or
pouring water into it.
Remove the head and all parts of the bowl. Removed: the head and all parts of the bowl can be washed under running water with
the addition of a mild dishwashing liquid. Dried sugar residues inside the head can lead to a loss of performance or even damage
to the product. If this happens, immerse the head in warm water with dishwashing liquid and leave it to soak, then clean with a
soft sponge and water with dishwashing liquid. Do not use brushes, metal dishwashers or other sharp objects to clean the parts
of the product.
Clean the device housing with a soft cloth dampened with a water and mild detergent solution. Wipe dry. Do not use abrasive
cleaning agents.
Make sure all parts are cleaned and dried before connecting the device to the power supply. Store the product in dry, shaded
conditions. Protect the storage place from unauthorised access, especially by children. Store the product in the unit packaging
provided with the product. Do not place anything on the product.

TECHNICAL PARAMETERS

Parameter
Catalogue No.
Rated voltage
Rated frequency
Rated power
Electrical protection class
Degree of protection of the housing (IP)
Bowl diameter
Weight
O R I G I N A L
12
GB
Unit of Measure
[V~]
[Hz]
[W]
[mm]
[kg]
I N S T R U C T I O N S
Value
68250
220 - 240
50 - 60
500
I
IPX0
295
1.2
Value
68251
220 - 240
50 - 60
500
I
IPX0
275
1