ATX Game ready Manual Del Usuario página 2

PRE-COOLING/PRE-HEATING YOUR WRAP
The Full Leg Boot is designed to deliver therapy over the entire leg and
foot (except the toes). During a therapy, a large amount of water is being
circulated through the Wrap. Pre-cooling/Pre-heating your Wrap will help to
deliver the best therapy possible. From time to time, you may see the actual
temperature deviate from the target temperature. This is normal.
PRE-COOLING YOUR WRAP WITH GRPRO 2.1
1. First, prime your Full Leg Boot. See Priming the Wrap.
PRE-COOLING YOUR WRAP WITH MED4 ELITE
1. Run a Cold Therapy with no compression for 2 to 3 minutes.
2. Once the actual reservoir temperature is within 2 - 3 °F (1 - 2 °C) of the
target temperature, the Wrap can be applied.
3. Stop the current therapy. Apply the Wrap.
4. Run a therapy as desired. Refer to the User Manual of your Control Unit.
PRE-HEATING YOUR WRAP WITH MED4 ELITE
1. Run a Heat therapy with No Compression for 2 to 3 minutes.
2. Once the actual reservoir temperature is within 2 - 3 °F (1 - 2 °C) of the
target temperature, the Wrap can be applied.
3. Stop the current therapy. Apply the Wrap.
4. Run a therapy as desired. Refer to the User Manual of your Control Unit.
NOTE: Never exceed the upper and lower markers when adjusting
the boot. The top edge should always be between the shortest and
longest in-seam markers.
2 of 6
2. With water in the Wrap, and
the water level of your Control Unit
at full, run a Cold Therapy with no
compression for 5 minutes.
This will allow the temperature of the
water in the Wrap to equalize with that
of the water in the GRPro 2.1 reservoir.
Run a therapy as desired. Refer to the
User Manual of your Control Unit.
ADJUSTING THE IN-SEAM LENGTH
The Full Leg Boot is designed to accommodate various in-seam lengths.
The Wrap comes ready to use with the standard length. If needed, you
may adjust the length to be either longer or shorter by following the steps
below.
TO LENGTHEN THE WRAP (LONGER IN-SEAM)
1. Detach the hook & loop of the boot section of the Wrap
so that the entire Wrap lays flat on the floor or table
2. Fold the boot section over so that the top edge aligns
with the lower marker (see icon at left). This will add
approximately 1" to the standard in-seam length.
Align top edge of boot
3. Secure the boot in place by folding the top piece of
to this line to lengthen
the in-seam length.
hook & loop toward you as shown.
TO SHORTEN THE WRAP (SHORTER IN-SEAM)
1. Detach the hook & loop of the boot section of the Wrap
so that the entire Wrap lays flat on the floor or table.
2. Fold the boot section over so that the top edge aligns
with the upper marker (see icon at left). This will subtract
Align top edge of boot
approximately 1" from the standard in-seam length.
to this line to shorten
the in-seam length.
3. Secure the boot in place by folding the top piece of
hook & loop toward you as shown.
1
2
3
The standard size
is shown in this
example.
Shortest
In-Seam
Fold flap
over to
secure
boot in
place
Longest
In-Seam