KMR 3447 Manual Del Usuario página 4

4 I English
1 TECHNICAL DATA
Type
Dimensions mm
Weight kg (without fasteners)
Single sequential
Recommended operating pressure
range
Maximun permissible operating
pressure
Air consumption per driving
operation
Magazine capacity. No. of
fasteners
Penetration depth setting
Fastener: Corrugated fastener
Height x width mm
Lenght mm
Recommended lubricant
1 litre special oil. Code No.
250 cm3 grasa especial. Code No.
2 NOISE / VIBRATION INFORMATION
Noise characteristic values *
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
A-weighted sound power level
L WA, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a),
a h, w, 3s
The noise level when working can exceed 85
dB (A). Wear ear protection!
* Measured values determined according to
EN 12549:1999.
** Measured values determined according to
ISO 8662-11:1999.
3 SUPPLIED WITH
1 Nailer for corrugated fasteners
1 Tool use and safety instructions
1 Technical data sheet
KMR
4
3447
Only those fasteners specified under technical data
(see 1) may be used.
315/415
When filling the magazine, hold the tool so that the
3,2 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
6 - 8,5 bar/
yoke or trigger depressed.
0,6 - 0,85 MPa
Pull back the catch lever (20 009) for release and open
8,5 bar/
the magazine. The corrugated fasteners must be
0,85 MPa
inserted with the red mark at the top. After loading
2,6 l bei 6
of the corrugated fasteners, close the magazine so
bar / 0,6 MPa
far until it engages.
80
5
no
3,0 x 35
Balancer for 30-55 N (3.0-5.5 kp),
cable travel 2.0 m (6.5 ft)
25
Suspension
9 4420
68 3868
3447
82 dB(A)
95 dB(A)
3,5 m/s2
FILLING THE MAGAZINE
ACCESSORIES
3447
Code No.
28 6478
71 3287