Replacement Of Batteries In Remote Controller - Saivod SAP1220 Serie Manual Del Usuario

Operation guide
1. After putting through the power, press "
turn on the air conditioner.
2. Press " " button to select your required mode: AUTO, COOL, DRY, FAN,
MODE
HEAT.
3. Press "+" or "-" button to set your required temperature. (Temperature can't be
adjusted under auto mode).
4. Press " " button to set your required fan speed: auto, low, medium and
FAN
high speed.
5. Press " " button to select fan blowing angle.

Replacement of batteries in remote controller

1. Press the back side of remote controller marked
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
NOTICE
● During operation, point the remote control signal sender at the receiving
window on indoor unit.
● The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
or wireless telephone; remote controller should be close to indoor unit during
operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the
batteries.
● If the display on remote controller is fuzzy or there's no display, please
replace batteries.
" button on remote controller to
ON/OFF
signal sender
Cover of battery box
battery
reinstall
remove