Connection - Panasonic TH-42PX6U Manual De Instrucciones

Accessories/Options
2
Setting-up
Remove the plasma television unit from its packing box, spread a clean blanket or other covering on a level
floor or stand, place the television on the floor or stand with its front panel facing down, and keep it like this
until installing it on the pedestal.
Securing the television unit
Television unit
Y Y
P B P B
VIDEO S VIDEO
P R R P
S E R V I C E
O N L Y A N T D I G I T A L L
A U D I O O U T AUDIO IN
R
1 2
COMPONENT VIDEO INPUT INPUT 1 INPUT 2 OUTPUT
Pedestal No. label
Pedestal
3
Preventing the plasma television from falling over
Securing to a base.
Front
Front
Wood
Worktop
Fasten with wood screws in the holes
in the back edge of the wood worktop.
If there are no holes, first drill them in
the middle of the thickness of the wood
worktop, and then fasten the strap with
wood screws.
* The plasma TV must be fastened to both the base and the wall.
8
* Carry out work on a horizontal and level surface.
Lift the television unit above the pedestal base,
with the back of the television unit on the same
side as the Pedestal No. label. Then align the
holes in the television unit with the poles of the
pedestal and lower the television unit into place.
Use the assembly screws (M5 x 30) to fasten
B
securely.
Rear
Securing to a wall.
Do not remove this screw.
* Remove the screws
at both top corners on
the rear side of the
plasma TV, and attach
the clamps
plasma TV using the
removed screws.
Screws on main body
• Securing method
* Use strong wire
or chain which is
commercially available
to secure the plasma
television to a solid
area of the wall or a
pillar.

Connection

■
Watching TV
Cable BOX
IN OUT
or
ANT IN
ANT OUT
Video recorder
with TV Tuner
to the
DVD Recorder /
VCR
Note
•
All cables and external equipment shown in this
book are not supplied with the TV.
•
For additional assistance, visit us at www.
panasonic.com
•
The S Video input will override the composite
video signal when S Video cable is connected.
Connect either S Video cable or Video cable.
•
When receiving digital channel signals, all digital
formats are down-converted to composite NTSC
video to be output through the PROG.OUT
terminals.
•
Some programs contain a copyright protection
signal to prevent VCR recording.
•
Set the TV channel to CH3 or CH4 for using
Cable Box Connection.
VHF/UHF aerial
or
S Video
OUT
Video
OUT
L
Audio
S-Video signals have
OUT
priority.
R
Video
To record TV shows
IN
L
Audio
IN
R
Attaching the Cable clampers
Back of the TV unit
•
Do not bundle the RF cable and AC cord together (could
cause distorted image).
•
Fix cables with Cable clampers as necessary.
•
When using the optional accessory, follow the option's
assembly manual to fix cables.
Back of the unit
S E R V I C E O N L Y
A N T A U D I O D I G I T A L O U T
Fastener
•
To unfasten
AC cord
(Connect after
all the other
connections.)
Snap open Snap shut
9