Num'axes CANICOM 200 Manual De Instrucciones página 19

Ocultar thumbs Ver también para CANICOM 200:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

u Activate/deactivate the receiver collar
A magnet located in the remote control is used to either switch on/off the receiver collar.
- Activate: approach the red area where the magnet is located inside the remote control until coming in
contact on red indicator located on the receiver collar, hold for 1 second (ref. Diagram 5), the indicator
light will flash in green indicating that CANICOM is on .
REMOTE CONTROL
- Deactivate: approach the red area where the magnet is located inside the remote control until coming
in contact on red indicator located on the receiver collar, hold for 1 second (ref. Diagram 5), the indicator
light will flash from green to red and then off: the collar is off .
To increase the battery life of the receiver collar, we recommend you deactivate the unit if you are no
longer using your CANICOM 200 for a long period.
u Coding of the remote control and receiver collar
Each remote control has its individual radio operator code. The coding of the remote control with the
receiver collar enables the two units to work together.
IMPORTANT: before beginning the coding, make sure no other person is using his CANICOM 200
or other products from the NUM'AXES range close by: your receiver collar could accidentally
record the code of his remote control. If that occurs, re-code the remote control with the receiver
collar.
Gb - 19
Diagram 5
Approach until coming in contact those 2 areas
during 1 second
COLLAR

Publicidad

Tabla de contenido
loading

Tabla de contenido