Num'axes CANICOM 200 Manual De Instrucciones página 22

Checking/Replacing battery of receiver collar
Changing the contact points
To check the condition of the receiver collar battery, observe the On/Off indicator located on the front of
the receiver collar:
• Battery fully charged: flashes slowly green.
• Weak battery: flashes quickly red. Replace it with a new battery (See § Fitting the battery in the receiver collar).
Check the receiver collar operates correctly.
How to check that your CANICOM 200 is functioning properly
Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit. Carefully tighten them manually (do
not use a key).
You can check that your CANICOM 200 is operating correctly at any time.
Getting the best results
- Before doing so, make sure that the receiver collar is turned « off ».
- Place the neon test lamp in contact with each of the contact points (by unscrewing them then by
screwing them up in order to grip wires of the lamp under the contact points).
- Turn « on » the remote control and receiver collar.
- Press the « F » or « C » button and modify the level of intensity of the stimulations: the test lamp will
come on with more or less intensity.
The training instructions you send to your dog are sent from the remote control to the receiver collar by
radio waves. These radio waves are sensitive and the range reaches approximately 200 meters
(depending on geography and environment).
The performances of your CANICOM 200 will be optimal if you respect the following
recommendations:
Gb - 22