Charging The Batteries; Charging Indications - Motorola PMPN4531 Manual Del Usuario

MN007338A01-AC
Chapter 2: Charger Operations
Chapter 2
Charger Operations
This sections contains the charging information of your charger.
2.1

Charging the Batteries

Prerequisites:Charge your Motorola Solutions Authorized Batteries best at room temperature with the
assigned power supply to the supported models.
Procedure:
1 Place the multi-unit charger on a flat surface.
NOTICE: If you have more than one multi-unit charger, it is recommended to place the
multi-unit charger in a vertical position mounted to the mounting bracket.
2 Insert the power supply adapter to the female connector of the multi-unit charger.
3 Plug the power supply adapter to the power outlet.
If powering up the multi-unit charger is successful, the LED shows green for one second.
If powering up the multi-unit charger is unsuccessful, check the power cord connection.
4 To insert the battery into the charger pocket, align the battery on the rail of the charger pocket.
5 Make sure the battery is in contact with the charger contact.
If the battery is inserted correctly, the LED indicator shows solid red.
6 To remove the battery from the charger pocket, pull the battery out from the charger pocket.
2.2

Charging Indications

Table 6: Charging Indications
Charger Indication
Solid green for 1 second
Solid red
Blinking green
Solid green
Blinking red
14
Description
Charger power up successfully.
Battery is charging rapidly.
Battery is charged up to 90% or more.
Battery is nearly charged or fully charged.
Battery is at fault.
NOTICE: Remove and re-insert the battery to the
charger pocket.