Replacing The Waste Toner Container - Canon imageRUNNER ADVANCE C3330i Guía De Asistencia

Replacing the Waste Toner
Container
When the waste toner container nears capacity, a
message appears on the touch panel display. In this case,
you should prepare a new waste toner container.
Even if you do not replace the waste toner container
immediately, you can perform printing for a while. The
number of prints you can make depends on the content
you print.
When the waste toner container is full, a screen
with instructions on how to replace the waste toner
container appears on the touch panel display. Follow the
procedure described below to replace the waste toner
container.
WARNING
Do not burn or throw used waste toner containers
)
into open flames. Also, do not store waste toner
containers in places exposed to open flames, as this
may cause the toner to ignite, resulting in burns or a
fire.
If you accidentally spill or scatter toner, carefully wipe
)
up the loose toner with a damp, soft cloth and avoid
inhaling any toner dust. Do not use a vacuum cleaner
that is not equipped with safety measures to prevent
dust explosions to clean up loose toner. Doing so may
cause damage to the vacuum cleaner or result in a
dust explosion due to static discharge.
CAUTION
If toner is ingested, consult a physician immediately.
)
If toner gets onto your hands or clothing, wash it off
)
immediately with cold water. Washing it off with warm
water will set the toner, and make it impossible to
remove the toner stains.
IMPORTANT
Your local authorized Canon dealer will dispose of
)
used waste toner containers.
Used toner cannot be reused. Do not mix new and
)
used toner together.
Use only waste toner containers intended for use with
)
this machine.
Do not replace the waste toner container before the
)
message prompting you to replace it appears on the
touch panel display.
NOTE
Complete instructions on how to replace the
)
waste toner container can be accessed by pressing
[Previous] or [Next] on the touch panel display.
If the waste toner container must be replaced during a
)
print job, the remaining prints are made after the new
waste toner container is installed.
50

Replacing the Waste Toner Container

01
Press .
02
Open the waste toner cover.
1. Pull out Paper Drawer 1.
2. Pull the tab, and open the cover of the waste toner
container.
2
03
Remove the waste toner container.
1. Grip the handle, and pull out the waste toner
container slowly until the entire handle on top can
be seen.
2. Grip the handle on top, and remove the waste toner
container.
CAUTION
Be careful not to drop the waste toner container when
you pull it out. Doing so may cause injury.
1