MSA GAG Serie Manual De Instrucciones página 17

KITFIX
D
• Attach the shield using the "Kitfix" fixing kits A and test to make
sure that the mask is airtight.
• To adjust mask tension on helmet B:
– remove the pin by means of pliers
– move the Kitfix towards position (1) (2) or (3) according to
desired mask tension
– lock the Kitfix by means of the pin (push in as far as possible)
To check that the helmet is correctly adjusted:
The helmet should not fall when the head is leaning forward and the
chin strap unfastened.
The face shield should not touch the nose.
E
• Place the neck protector upside-down above the helmet.
• Place, then clip the four studs of the protector on the two studs
of the Multi-point support and on the two studs of the inner shell,
near the ratchet cradle.
• Assembly the four front quick-fastening straps.
KITFIX
NECK CURTAIN
The Safety Company
D
A
B
(1) (2) (3)
A
(1)
B
(2)
(3)
15
GB