Loading Nails; Nailer Operation - Metabo HPT NT 1850DF Instrucciones Y Manual De Seguridad

English
Depress the push lever against the workpiece within
2 seconds.
□ THE NAILER MUST OPERATE.
(9) If no abnormal operation is observed, you may load
nails in the Nailer.
Drive nails into the workpiece that is the same type to
be used in the actual application.
□ THE NAILER MUST OPERATE PROPERLY.

LOADING NAILS

● When loading nails into Nailer,
1) remove battery from the nailer;
2) do not pull trigger;
3) do not depress push lever; and
4) keep nailer pointed downward.
(1) Lightly press the stop lever and gently pull out the
magazine cover.
Magazine cover
(2) Set nail strip into the magazine and keep the points of
nails in contact with Groove.
Nails strip
Magazine
22
WARNING
Press
Pull out
Stop lever
Groove
NOTE
● The nails shown in page 13 can be loaded onto
the side guide groove of the magazine without any
adjustment.
Always keep the points of nails in contact with
Groove.
Magazine
Side guide
groove
Nail
Groove
(3) Slide the nail strip into the blade guide.
Blade guide
(4) Confi rm that nail strip is placed with side guide
grooves and Groove properly, then push the
magazine cover forward to be latched.

NAILER OPERATION

Read section titled "SAFETY" (pages 3–10).
● Operators and others in
work area MUST wear safety
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
Gap
Nail strip
DANGER