Nailer Operation - Metabo HPT NR 38AK Instrucciones Y Manual De Seguridad

(3) Pull the nail feeder back with depressing the feeder
plate knob to push the nail strip.
Feeder Plate Knob
NOTE: Use nail strip of more than 4 nails.
The Nailer is now ready to operate.
Removing the nails:
1 Depress the feeder plate knob slightly and slowly
slide the nail feeder forward.
2 Remove the nails from the Nailer.

NAILER OPERATION

Read section titled "SAFETY" (pages 4 – 8).
● Operators and others in work
Ordinary eyeglasses do not
provide adequate protection.
● Be sure to position and insert the fi rst
nail point through the hole in the metal
connectors, and never drive nails into metal
or concrete.
Nail
Feeder
Feeder
Plate Knob
DANGER
area MUST wear
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
• pre-punched holed
metal
• wood
If the nail is driven into metal or concrete directly, it
could ricochet and hurt yourself as well as others.
● Keep fi ngers AWAY from trigger when not
driving nails to avoid accidental discharge.
● Know and understand what trigger system
you are using.
Please read and understand "Methods of
Operation" below.
● Never place your hands or body closer than 8
inches (200 mm) from fi ring head when using.
● Do not drive nails into other nails; nails can
ricochet and hurt someone.
● Do not actuate Nailer unless Nailer is placed
fi rmly against the workpiece.
● Use only genuine metabo HPT hardened
nails for this NR38AK.
● Always point fi rst nail protruded from the
nose away from yourself and others.
● Do not push tool forward when positioning
the fi rst nail in hole.
● When working close to an edge of a
workpiece or at steep angles, or driving
fasteners into thin workpiece use care to
minimize chipping, splitting or splintering, or
free fl ight, ricochet or piercing of fasteners,
safety
which may cause injury.
● Never drive nails from both sides of a wall
at the same time. Nails can be driven into
and through the wall and hit a person on the
opposite side.
● Never use Nailer which is defective or
operating abnormally.
● Do not use Nailer as hammer.
YES
• no-holed metal
• concrete
WARNING
● Only person who have read
and understand
MANUAL should operate the
Nailer.
● NEVER point tool at yourself
or others in work area.
English
NO
this
15