Kit Assembly - Metra 99-8912HG Instrucciones De Instalación

DIN radio provision with pocket
1. Attach the (4) panel clips provided to
the radio trim panel (Figure A)
2. Secure the pocket to the radio brackets
using (4) Phillips screws provided.
(Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the bracket/pocket
assembly, then secure using screws
supplied with the radio (Figure C)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or AXXESS.
Test the radio for proper operation.
6. Slide the radio into the dash, then secure
using the factory screws. Clip the radio
trim panel over the completed assembly
to complete the installation.

KIT ASSEMBLY

(Figure A)
(Figure B)
(Figure C)
ISO DDIN radio provision
1. Attach the (4) panel clips provided to
the radio trim panel (Figure A)
2. Secure the radio brackets to the radio
using screws supplied with the radio.
(Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or AXXESS.
Test the radio for proper operation .
4. Slide the radio into the dash, then secure
using the factory screws. Clip the radio
trim panel over the completed assembly
to complete the installation.
(Figure A)
(Figure B)
REV. 4/1/2020 INST99-8912HG
3