Carrier 40VD005S-7S-QEE Manual De Instalación Y Propietario página 27

Electrical Wiring
(A) Definition and description of SW03
SW0 3_1 Address
setting mode
SW032 Code-
set indoor
SW038
unit address
and
centralized
controller
address
(Note2)
Note* :
• Set the address by code when connecting the centralized controller or gateway or charge system.
• Address of the centralized controller = communication address + 0 or + 64. SW03_ 2 = OFF, address of the centralized
controller = communication address + 0 = communication address SW03_ 2 = ON, address of the centralized controller =
communication address + 64 (applies when the centralized controller is used and there are more than 64 indoor units).
• To use with 0010451181A in use, using code for address setting is required. Set SW03_1 = 0N and SW03_ 2 = OFF; SW03_3,
SW03_ 4, SW03_5, SW03_6, SW03_7, and SW03_ 8 are address codes that are set according to the actual address. The
address-setting function of the wired controller for ultrathin card machines is disenabled.
[1]
0
1
[2] [3] [4] [5] [6]
0 0 0 0 0
0 0 0 0 0
0 0 0 0 0
... ... ... ... ...
0 1 1 1 1
1 0 0 0 0
1 0 0 0 0
1 0 0 0 0
... ... ... ... ...
1 1 1 1 1
Address setting mode
Automatic setting (default)
Code-set address
[7] [8] Address of
indoor unit
0 0 0# (Default)
0 1 1#
1 0 2#
... ...
1 1 63#
0 0 0#
0 1 1#
1 0 2#
... ...
1 1 63#
20
Address of
centralized
controller
0# (Default)
1#
2#
63#
64#
65#
66#
127#