Publicidad
Idiomas disponibles
Idiomas disponibles
2.4
Attach the Slide Mount End Caps with 6mm button head
cap screws. Ensure screws are fully driven, fully seated
and not stripped (See Figure 5).
2.5
Slide the Rear Rack Corner towards the rear of the bed.
When at the desired position, allow the pin to engage
into a hole in the rail. Install and tighten two lock down
Knobs on the Slide Mount corner base.
2.6
Install the Passenger's Side Rear Rack Corner by
repeating step 2.2 on the passenger's side of the truck
bed. Note: Do not yet install Knobs or End Caps to
Slide Mount.
FIGURE 5
ORIENTATION:
LARGER EDGE
TOWARDS
RAIL FACE
TOP VIEW
6MM BUTTON HEAD SCREW
2.7
IMPORTANT: To assure the Rear Rack Assembly
slides freely on the cargo management track when fully
assembled, position the Passenger's Side Rear Rack
Corner precisely across from the Driver's Side Rear
Rack corner using the holes in the cargo management
rails as reference points and insert the Centering Aids to
correctly align the Slide Mount corner base of the
Passenger's Side Rear Rack Corner (See Figure 6).
Install and tighten the two Knobs onto the Slide Mount
corner base.
GMT900 Commercial Overhead Rack Set
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
SLIDE
MOUNT
END CAP
REVISION
FIGURE 6
2.8
To preassemble the Crossbars insert six 10mm T Bolts
into the bottom slot, three towards each end of the
Crossbar. IMPORTANT: Be sure to orient the Crossbar
with the flat indentation facing down (See Figure 7).
FIGURE 7
RAISED EDGE
CROSSBAR
SADDLE
PLATE
PART NO.
REV 09OC06
INSTALLATION INSTRUCTIONS
AUTH
DR
TITLE
GMT900 Commercial Overhead Rack Set
PART NO.
19157544
6200 Grand Pointe Dr., Grand Blanc, MI 48439
CENTERING
AID
INDENTATION
19157544
SHEET
3
SHEET
FLAT
3
15
OF
15
OF
Publicidad
