Lavorwash CALIFORNIA ANTARTIC Manual Del Usuario página 17

the pump.
with A.S.S – Automatic Stop System: these
appliances should not be left in standby for
more than 5 minutes.
Switch the appliance off
completely (master switch on (0)OFF)
whenever it is left unattended.
Every machine is tested in its
operating conditions, so it is normal for a few
drops of water to be left inside it.
Take care not damage the
electric cable. If the supply cord is damaged,
it must be replaced by the manufacturer, its
service agent or similarly qualified persons in
order to avoid a hazard
Appliance with fluid under
pressure. Keep a firm hold on the gun and be
prepared to take the kickback pressure. Only
use the high pressure nozzle provided with
the appliance.
16 This appliance is not intended
for use by persons (including children)
with reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use
of the appliance by a person responsible for
their safety.
17 Children should be supervised
to ensure that they do not play with the
appliance.
18 Never start the high-pressure
cleaner without first completely unwinding
the high-pressure hose.
19 When winding and unwinding
the pipe take care not to cause the high-
pressure cleaner to overturn.
20 Before unwinding or winding
the hose, switch the machine off and release
the pressure in the hose itself (switching
off).
21 Risk of explosion — Do not
spray flammable liquids.
22 To
safety, use only original spare parts from
the manufacturer or approved by the
manufacturer.
23 Do not direct the jet against
yourself or others in order to clean clothes or
foot-wear.
Appliances equipped
ensure machine
24
shall not be used by children or untrained
personnel.
: Water that has flown through
backflow preventers is considered to be
non-potable.
disconnected from its power source, by
removing the plug from the socket-outlet,
during cleaning or maintenance and when
replacing spare parts
If an extension cord is used,
the plug and socket must be of watertight
construction.
Inadequate extension cords
can be dangerous.
It is absolutely forbidden to
use the machine in potentially explosive
environments or areas.
- NEVER EVER TOUCH THE MACHINE WITH WET
HANDS OR BARE FEET.
- NEVER PULL THE POWER SUPPLY CABLE OR
MACHINE IN ORDER TO DISCONNECT THE PLUG
FROM THE SOCKET.
- IF DURING FUNCTIONING THE POWER SUPPLY
RUNS OUT, FOR SAFETY REASONS, TURN THE
MACHINE OFF.
the gun is fitted with a safety
catch. Whenever use of the machine is
interrupted it is important to operate the
safety catch to prevent accidental activation
of the jet.
- Safety features: gun equipped with safety
locking device, appliance equipped with
(Class I) overload cutout, pump equipped
with by-pass valve or shutdown device.
- The safety button on the gun is not there
to lock the lever during operation, but to
prevent its accidental operation.
The appliance is equipped
with a motor protection device: in case of
device intervention, wait some minutes or,
in alternative, disconnect and re-connect
the product to the electric system. In case
this problem repeats again or if the product
does not start again, take the product to the
nearest After Sales Service Point
High pressure cleaners
the machine shall be
EN
17