Lavorwash CALIFORNIA ANTARTIC Manual Del Usuario página 21

Cause Insufficient flow.
Water inlet filter is clogged.
Suction/delivery valves are
clogged or worn out.
Pressure regulator valve set
on minimum.
The nozzle is worn out.
Repair Check that the delivery rate is
30% higher than the value stat-
ed on the appliance's technical
data plate.
Remove and clean the filter.
Contact an authorised service
centre.
Increase the pressure by
screwing in the pressure regula-
tor knob.
Replace the nozzle.
Fault
Cause The nozzle is either clogged or
deformed.
Suction/delivery valves are
clogged or worn out.
Worn gaskets.
Pressure regulator valve gas-
kets worn.
The filter is dirty.
Repair Dismantle the lance and clean
the nozzle with
the pin provided.
Contact an authorised serv-
ice centre.
Contact an authorised serv-
ice centre.
Contact an authorised serv-
ice centre.
Remove and clean the filter.
Fault
Cause Water leaking from the pump.
Leaks from hose reel (if
present).
Leaks from pressure regulator
valve.
Leaks from water unions.
Repair
centre.
problem persists, contact an
authorised service centre.
centre.
problem persists, contact an
authorised service centre.
Fault Abnormal noise
Cause
clogged or worn out.
Repair
centre.
centre.
50°.
Fault
Cause
worn out.
Repair
centre.
Fault The machine does not suck
wax or detergent
Cause
position.
gent suction system.
Repair
quency that is suggested.
sition.
>
For any problems not mentioned in this manual, or if
Contact an authorised service
Tighten the unions; if the
Contact an authorised service
Tighten the unions; if the
Suction/delivery valves are
Worn bearings.
The filter is dirty.
Extreme water temperature.
Contact an authorised service
Contact an authorised service
Remove and clean the filter.
Bring the temperature under
O-rings (water and oil) are
Contact an authorised service
Tanks empty.
Rod knob on high pressure
Disconnected pipe in deter-
Replace oil with double fre-
Fill the tanks.
Turn it to the low pressure po-
Return it into position.
EN
21