Kit Assembly - Metra 99-8236 Instrucciones De Instalación

DIN radio provision with pocket
1. Slide the brackets onto the sides of the
radio housing until the side clips engage.
(Figure A)
Note: Tabs are marked Left and Right.
2. Remove the metal DIN sleeve from the
aftermarket radio.
3. Slide the sleeve into the radio housing
and secure by bending the metal locking
tabs down. (Figure B)
4. Slide the radio back into the sleeve until
it clicks in. (Figure C)
5. Snap the trim plate into the radio
housing. (Figure C)
6. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or AXXESS.
Test the radio for proper operation.
7. Reassemble the dash in reverse order of
disassembly.

KIT ASSEMBLY

(Figure A)
(Figure B)
(Figure C)
ISO DIN radio provision with pocket
1. Slide the brackets onto the sides of the
radio housing until the side clips engage.
(Figure A)
Note: Tabs are marked Left and Right.
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Secure the ISO brackets to the radio
with the screws supplied with the radio.
(Figure B)
4. Slide the radio/bracket assembly into
the radio housing until the side clips
engage. (Figure C)
5. Snap the trim plate into the radio
housing. (Figure C)
6. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or AXXESS.
Test the radio for proper operation .
7. Reassemble the dash in reverse order of
disassembly.
(Figure A)
(Figure B)
(Figure C)
REV. 9/28/2020 INST99-8236
3