Getting Started; Assembling Your Steam Pocket® Mop - Shark S6003EUDB Manual Del Usuario

Getting Started

When assembling your Steam Mop there may be a little water in or around the water tank. This is because we test all our Steam Mops before you
buy them, so you get a quality Shark Klik n' Flip® Steam Pocket
®
J
M
N
a Steam Mop Handle
b Quick-Release Cord Holder
c Cord Management Clip
d Filling Flask (clips to Steam Mop pole)
e Steam Mop Pad Release Button
f
Steam Mop Body
g Water Tank Lid
34
Mop.
®
A
B
C
D
E
F
G
H
I
K
L
h Steam Control Button
i
Water Tank
j
Mop Head Release Button
k Secondary Release Buttons
l
Steam Blaster Nozzle
m Klik n' Flip® Mop Head
n Dirt Grip Pad (x4)
Assembling Your Steam Pocket
fig. 2b
fig. 1 fig. 4
WARNING: Always make sure the Steam Mop is UNPLUGGED
when not in use. Never fill the Steam Mop or attach the mop
head when the Steam Mop is plugged into an electrical outlet.
Unplug from the electrical outlet and allow to cool before you
fill the Steam Mop, or attach or remove the head. To prolong
the life of your Steam Mop, we recommend using distilled
water. Make sure you add only water to the tank. Chemicals or
cleaning solutions (including vinegar) may damage the Steam
Mop and could be unsafe for you and your family.
STEAM MOP ASSEMBLY
1
Insert the Steam Mop handle into the Steam Mop body. Push the
handle in until you hear it click into place. (fig. 1)
2 Slide the Klik n' Flip® Mop Head into the Steam Mop body. Push
until you hear it click securely into place. (fig. 1) To detach the
Klik n' Flip® Mop Head, press the release button (fig. 2a) and slide
off.
3 To attach the Dirt Grip pad, spread the pad on the floor with the
pocket side up. Center the Klik n' Flip® Mop Head above the pad,
then press the pad release button on the back of the Steam Mop
body. (fig. 2a) Both sides of the Klik n' Flip® Mop Head will drop
open. (fig. 2b) Slip the Klik n' Flip® Mop Head's four corner tabs
Mop
®
fig. 2a
fig. 3
fig. 5 fig. 6
into the four corner pockets of the pad. (fig. 3 and fig. 4) Gently
press one side of the Klik n' Flip® Mop Head to the floor until that
side clicks into place. (fig. 5) Repeat on the other side. (fig. 6)
4 Pull down on the water tank lid to open. (fig. 7)
5 Use the filling flask to pour water into the water tank. (fig. 8)
Water can be poured into the tank directly. Do not overfill past
the water line on the fill flask. Press the water tank lid firmly to
close it.
fig. 7
fig. 8
s h a r kc l e a n . e u 35