Wheels And Tyres; Asseccories; Therapy Table - B+B S-Eco 2 Manual De Instrucciones

S-ECO 2
| Standard wheelchair

4.5. Wheels and tyres

The spoked wheels are tightened with a power socket wrench (M12) on
the chassis suspension. (Fig. 18).
Drive wheels
Your „S-Eco 2" has puncture-proof PU tyres with tubes size 24x13/4"
as standard equipment. The tyres must be replaced by your authorised
18
dealer when they are worn or faulty.
Steering Wheels
Your S-Eco2 has puncture proof PU steering wheels without a valve 7"
in diameter (Fig.19). Faulty or worn out wheels must be changed by an
qualified mobility dealer.
19
4.5.1. Floating axle (optionally)
In order to make the transport of your wheelchair easier there is an
option to equip the wheels with floating axles. The model with the
floating axles makes it possible that the wheels can be removed
without any tools. The principle is quite simple:
• Push the brake lever button of the floating axle with your finger
and remove the wheel.
• When you want to mount the wheel back just insert it on the
holder. You also have to push the brake lever button when doing so.
19
To achieve optimal braking safety of your
wheelchair, the air pressured turnover wheels must
have an air pressure of 200- 250 k pa (2-2, 5 bar).
Standard wheelchair |

5. Asseccories

5.1. Anti-tipping wheels
Always use the anti-tipping wheels in pairs.
To assemble the anti-tipping wheels proceed as follows:
• First detach the rubber profiles of the tilt aid from the frame.
• Push the round profile of the anti-tipping wheels on the side frame
pipe.
• Now bolt the tilt protection with a screw M 6 x 35 and a self-
locking nut M6 in the designated drilling on the frame.

5.2. Therapy table

If the side parts are mounted in the long position then the table is
attached on the provided guides in front of the armrest. If you want to
remove the therapy table just pull it out.
At "Desk" side parts with padded armrest the table is put on with
accompanying guides and is fastened with star knob screws. To remove
the therapy table first unfasten the star screws and then pull out the
table.
Bischoff & Bischoff GmbH | 13.02.2020
S-ECO 2
20