Publicidad
5. Route the T-Connector ends with the Green wires to the
right (passenger) side of the vehicle. Repeat step 4 on the
passenger side using the T-Connector ends containing the
Green wire.
6. Route the T-connector harnes ends with the yellow and
brown wires under the vehicle to the left (driver's) side.
Repeat steps 4 & 5 for the left (driver's) side, using the
T-Connector ends containing the yellow and brown wires.
7. Locate a clean accessable ground stud near the T-
Connector's White wire. Loosen the ground bolt, insert
through the ring terminal on the T-Connector's White
wire and return the bolt to its original position, tighening
appropriately.
8. Mount the T-Connectors black box within the tail light
opening or other flat surface using foam tape, screws or
cable ties.
Caution: If mounting with screws, take care not to
drill through the body or any exposed surface.
9. Test the installation using a test light or properly
equipped trailer.
10.All loose wires should be secured using cable ties or
other similar mounting devices. Return all acess panels,
trays and thresholds to their original positions. Store the 4-
Flat connector in the vehicle trunk or rear cargo area when
not in use.
Publicidad
