Emc Information - Philips RESPIRONICS SimplyGo Manual De Usuario

SimplyGo User Manual

EMC Information

Guidance and Manufacturer's Declaration – Electromagnetic Emissions
This device is intended for use in the electromagnetic environment specified below� The user of this device should assure that it
is used in such an environment�
Emissions Test
RF Emissions
CISPR 11
RF Emissions
CISPR 11
Harmonic Emissions
IEC 61000-3-2
Voltage Fluctuations/Flicker Emissions
IEC 61000-3-3
Emission of Radio Frequency Energy
RTCA/DO-160G Section 21
Guidance and Manufacturer's Declaration – Electromagnetic Immunity
This device is intended for use in the electromagnetic environment specified below� The user of this device should assure that it
is used in such an environment�
Immunity Test IEC 60601 Test Level
Electrostatic ±8 kV contact
Discharge (ESD) ±2 kV, ±4 kV, ±8 kV, &
IEC 61000-4-2 ±15 kV Air
Electrical Fast ±2 kV for Power Supply
Transient/Burst Lines
IEC 61000-4-4 ±1 kV for Input/Output
Lines
Surge ±1 kV Line to Line
IEC 61000-4-5 ±2 kV Line to Ground
Voltage Dips, Short 0% U
Interruptions and 45 deg inc
Voltage Variations on
Power Supply Input 0% U
Lines
IEC 61000-4-11 70% U
(30 cycles if US)
0% U
Power Frequency 30 A/m
(50/60 Hz) Magnetic
Field
IEC 61000-4-8
Note: U is the A�C� mains voltage prior to application of the test level�
T
46
Compliance
Group 1
Class B
Class A
Complies
Category M
Compliance Level
±8 kV contact
±2 kV, ±4 kV, ±8 kV, &
±15 kV Air
±2 kV for Power Supply
Lines
NA- Device does not have
user I/O lines that are
longer than 3m in length�
±1 kV Line to Line
NA- The device is a Class
II device and does not
connect to earth ground�
0�5 cycle, 0% U
T T
45 deg inc
1 cycle 0% U
T T
25 Cycles 70% U
T
(30 cycles if US)
5 sec 0% U
T T
30 A/m
Electromagnetic Environment - Guidance
The Device uses RF energy only for its internal
function� Therefore, its RF emissions are very
low and are not likely to cause any interference
in nearby electronic equipment�
The Device is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network
that supplies buildings used for domestic
purposes�
The Device is suitable for use onboard
commercial airplanes inside passenger cabin�
Electromagnetic Environment - Guidance
Floors should be wood, concrete or ceramic tile�
If floors are covered with synthetic material, the
relative humidity should be at least 30%�
Mains power quality should be that of a typical
home or hospital environment�
Mains power quality should be that of a typical
home or hospital environment�
0�5 cycle, Mains power quality should be that of a typical
home or hospital environment� If the user of the
Device required continued operation during
1 cycle power mains interruptions, it is recommended
that the Device be powered from an
25 Cycles uninterruptible power supply or battery�
T
5 sec
Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical home or hospital environment�