Adjusting The Insertion Depth - Prebena 3X-CNW50 Manual De Instrucciones Original

Operating the fastener driving tool
The selector switch for making the triggering setting is located on the
trigger of the fastener driving tool. On fastener driving tools 3X-CNW50,
4X-CNZ45 and 7F-CNW90, the selector switch is red, on fastener driving
tools 5F-CNW65 and 8XR-CNW90, the selector switch is black.
To select the triggering setting, follow these steps:

Press out the selector switch (1) on the trigger (1.)
and hold it depressed.

Adjusting the insertion depth

Types 3X-CNW50, 4X-CNZ45 and 5F-CNW65
For fastener driving tools 3X-CNW50, 4X-CNZ45 and 5F-CNW65,
you can adjust the insertion depth of the coil nail by adjusting
the setting wheel and changing the operating pressure
of the compressor.
The following symbol appears on the housing
of the fastener driving tool:
28
The triggering setting is identified
on the trigger. Driving in a single
nail is marked by "T" repeated
driving in by "TTT".

Turn the selector switch
to the desired position (2.).
The point of the selector switch
is pointing at the selected setting.

Then allow the selector switch
to engage.
The triggering setting is now
selected.
This symbol shows the direction
the setting wheel must point in
to reduce or increase the insertion
depth.

To change the insertion depth,
turn the setting wheel (1) in the
desired direction.